Siemens SINUMERIK 840D sl Function Manual page 925
Hide thumbs
Also See for SINUMERIK 840D sl:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Advertisement
● Aborting the coupling with NC start:
● Write-protection for coupling parameters:
14.3.1
Configuration of the behavior with NC start
The response to NC machining program start is defined by the channel-specific machine
data.
Table 14- 2
Coupling is maintained
Deselect coupling
Activate configured data
Activate coupling
*see Section "Configuration of a synchronous spindle pair via machine data"
Extended Functions
Function Manual, 03/2009, 6FC5397-1BP10-4BA0
channel-specific MD21330 $MC_COUPLE_RESET_MODE_1
(channel-specific MD21340 $MC_COUPLE_IS_WRITE_PROT_1)
It can be defined in this machine data whether or not the configured coupling parameters
Speed ratio, Type of coupling and Block change response may be influenced by the NC
part program.
0: Coupling parameters can be changed by the NC part program
1: Coupling parameters cannot be changed by the NC part program. Attempts to make
changes are rejected with an alarm message.
Synchronous coupling behavior with NC start
Configured coupling
MD COUPLE_RESET_MODE
Bit 0 = 0
Bit 0 = 1
Bit 5 = 1
Bit 9 = 1
Configuration of a synchronous spindle pair via machine data
Synchronous Spindles (S3)
Programmed coupling *
MD START_MODE_MASK
Bit 10 = 0
Bit 10 = 1
-
-
925
- Quick Links:
- Table of Contents
Hide quick links:
Advertisement
Chapters
Table of Contents
