Using A Crane To Lift A Transport Unit Or The Drive By The Base Frame - ABB ACS5000 User Manual
Water-cooled
Hide thumbs
Also See for ACS5000:
- User manual (180 pages) ,
- User manual (178 pages) ,
- User manual (186 pages)
Table of Contents
Advertisement
4.5.1
Using a crane to lift a transport unit or the drive by the base frame
⚠
CAUTION
Tipping hazard!
• To prevent the drive or transport unit from tipping when following
these instructions, use an extra sling around the cabinet for
stabilization (Fig. 4-2).
▲
NOTICE
Risk of component damage.
To prevent deformation of the cabinet:
• Only use a crane to lift single transport units or the drive by the
base frame.
• Always observe the center of gravity!
Refer to Fig. 4-1 and Fig. 4-2 when following these ABB recommendations:
• Use a lift frame or a lift spreader with the crane.
• If a lift frame or lift spreader is not available, make sure that the
slope angle is a maximum of 15° (see Fig. 4-2).
• Use lifting equipment (eg, web slings, chain slings, round slings,
safety hooks, shackles) that corresponds to the weight that is to
be lifted.
• Attach the slings to the lifting brackets at the base frame.
• To prevent the drive or transport unit from crashing if one sling
tears, fasten an extra sling around the cabinet for stabilization.
• Use appropriate safety hooks or shackles to attach a sling.
• Do not pass a sling through the hole of the bracket.
• If the slings are too close to the cabinet, protect the edges and the
door handles or levers.
• Lift the drive or a transport unit slowly and steadily to the required
clearance height, maintaining it in upright position.
• Check the horizontal position and reposition the slings if necessary.
Figure 4-1 Lifting bracket on base frame of a drive and safety hook secured to
(1) Lifting bracket (hole ∅42 mm)
3BHS799208 E01 REV E
1
lifting bracket
(2) Safety hook
ACS5000 WATER-COOLED USER MANUAL
04 TRANSPORTATION, STORAGE AND DISPOSAL
2
68/186
Hide quick links:
Advertisement
Table of Contents
