Sony CCP-8000 Installation Manual page 47
Center control panel pack
Hide thumbs
Also See for CCP-8000:
- User manual (563 pages) ,
- System setup manual (134 pages) ,
- Operation manual (36 pages)
Table of Contents
Advertisement
5. Installation of the MKS-8025MS to the MKS-
8076 (Memory Card/USB Adapter)
Applicable module
. MKS-8025MS
Memory Stick/USB Module
n
1/2-wide and 1/3-wide cases are supplied with MKS-
8025MS. When you install the MKS-8025MS to the MKS-
8076, only the 1/2-wide case can be used.
Installation
1. Remove the module covers from the both sides of the
MKS-8025/8025MS.
2. Loosen the four screws (with drop-safe) fixing the
MKS-8025/8025MS.
3. Remove the MKS-8025/8025MS by holding the two
screws on the sides of the MKS-8025/8025MS.
4. Disconnect the harness from the MKS-8025/8025MS
connector.
5. Secure the ground terminal to an MKS-8025MS (new)
by the supplied screw (PSW3 x 5), then install the
MKS-8025MS (new) into the 1/2-wide case.
PSW3 x 5
Ground
terminal
1/2-wide case
6. Connect the harness of the MKS-8076 to the connector
of the MKS-8025MS (new).
7. Install the MKS-8025MS (new) and fix it by tighten-
ing the four screws (with drop-safe) on both sides.
CCP-8000 IM
MKS-8025MS
8. Install the module covers.
m
. The number of the MKS-8025MS that can be
connected to the MKS-8010/8010A is only one unit.
. When you want to joint it, install MKS-8025MS at
the top end. (Refer to Fig. 1 (on page 2-8.))
Screws
(with drop-safe)
Connector
MKS-8076
2-4. Installing the Operation Modules
Module covers
Screws
(with drop-safe)
MKS-8025MS
2-7
Hide quick links:
Advertisement
Table of Contents
