Sony CCP-8000 Installation Manual page 32
Center control panel pack
Hide thumbs
Also See for CCP-8000:
- User manual (563 pages) ,
- System setup manual (134 pages) ,
- Operation manual (36 pages)
Table of Contents
Advertisement
1-10. Checks on Completion of Installation
D919 (A-5) : MAIN CPU status LED
Main CPU status indication.
Used only for production in the assembly factory.
ND480 (B-7) : COM0 CPU status LED
CTRL LAN control IC status indication.
ND481 (B-7) : COM0 CPU status LED
CTRL LAN control IC status indication.
ND610 (B-8) : COM1 CPU status LED
PERIPH LAN control IC status indication.
ND611 (B-8) : COM1 CPU status LED
PERIPH LAN control IC status indication.
ND900 (B-5) : MAIN CPU status LED
Main CPU status indication.
ND901 (B-5) : MAIN CPU status LED
Main CPU status indication.
<Switch>
S310 (B-5) : MAIN RESET switch
Reset switch for the entire CA-45 board.
S311 (B-5) : Monitor reset switch for the main CPU
Reset switch that is used during maintenance of the main
CPU from the TERMINAL pin.
S480 (B-7) : C0-RESET switch
Independent reset switch for the CTRL LAN control IC.
S481 (B-7) : Modes setting switch for COM0 CPU
Used only for production in the assembly factory.
Default setup when shipped from the factory is all OFF.
S482 (B-7) : Monitor reset switch for the COM0 CPU
Reset switch that is used during maintenance of the CTRL
LAN control IC from the TERMINAL pin.
S610 (B-8) : C1-RESET switch
Independent reset switch for the PERIPH LAN control IC
CPU.
S611 (B-8) : Modes setting switch for COM1 CPU
Used only for production in the assembly factory.
Default setup when shipped from the factory is all OFF.
1-24
S612 (B-8) : Monitor reset switch for the COM1
CPU
Reset switch that is used during maintenance of the
PERIPH LAN control IC from the TERMINAL pin.
S900 (B-5) : Mode setting switch for the main CPU
Used only for production in the assembly factory.
Default setup when shipped from the factory is all OFF.
S901 (A-4) : Unit ID setting switch for LAN
Sets the unit ID of the equipment inside the network.
Used to set the unit ID for the CTRL, PERIPH and DATA
terminals.
Refer to the System Setup Manual for details.
S902 (A-3) : Group ID setting switch for LAN
Sets the ID of the network group.
Used to set the group ID for the CTRL, PERIPH and
DATA terminals.
Refer to the System Setup Manual for details.
S903 (A-6) : STATION ID
Used to set the REMOTE terminal.
Refer to the System Setup Manual for details.
<Connector>
CN203 (A-5) : TERMINAL pin
Main CPU connection terminal.
Used only for production in the assembly factory.
CN440 (A-10) : TERMINAL pin
Main CPU connection terminal.
Used only for production in the assembly factory.
CN482 (A-7) : TERMINAL pin
Main CPU connection terminal.
Used only for production in the assembly factory.
CN612 (A-8) : TERMINAL pin
Main CPU connection terminal.
Used only for production in the assembly factory.
CN802 (A-9) : JTAG connector
Used only for production in the assembly factory.
CCP-8000 IM
Hide quick links:
Advertisement
Table of Contents
