Sony CCP-8000 Installation Manual page 25
Center control panel pack
Hide thumbs
Also See for CCP-8000:
- User manual (563 pages) ,
- System setup manual (134 pages) ,
- Operation manual (36 pages)
Table of Contents
Advertisement
3. Attach the right and left adaptors to the rack complete-
ly using the specified six screws.
(The illustration below shows the left adaptor.)
Rack
B4 x 10
3U
1U
Adaptor
MKS-8010
: 3U
MKS-8010A
: 1U
4. Tighten the screws (B4 x 6 : two screws each on the
right and left) for adjusting the length of the adaptor
completely (the screws that were loosened in step2).
5. Align the groove of the rack tool at the side of the equip-
ment with the rail, and slide the equipment to the rear.
n
The rack tools are hooked on the rails as shown below.
Rack tool
Rail
6. Remove the front panel. (Refer to Section 2-1.)
CCP-8000 IM
Adaptor
31.75
Rack
B4 x 10
31.75
Unit : mm
Rack tool
Rail
7. Fix the rack angle in the rack using the specified
screws.
B 5 x 12
The illustration shows the MKS-8010A.
8. Attach the front panel to the equipment.
1-7. Rack Mounting
B 5 x 12
1-17
Hide quick links:
Advertisement
Table of Contents
