Logging In Through The Aux Port; Introduction - HP A-F1000-E Getting Started Manual
High-end firewalls
Hide thumbs
Also See for A-F1000-E:
- Product end-of-life disassembly instructions (3 pages) ,
- Installation manual (75 pages)
Table of Contents
Advertisement
Figure 23 Log in to another device from the current device
NOTE:
If the SSH client and the SSH server are not in the same subnet, make sure that the two devices can reach
each other.
Configuration procedure
Follow these steps to configure the SSH client to log in to the SSH server:
To do...
Log in to an IPv4 SSH
server
Log in to an IPv6 SSH
server
NOTE:
You can configure other settings for the SSH client to work with the SSH server. For more information, see
System Management and Maintenance Configuration Guide
Logging in through the AUX port
Introduction
As shown in
For a device that has separate console and AUX ports, you can use both to log in to the device to
facilitate system maintenance.
Figure 24 AUX port login diagram
By default, AUX port login adopts password authentication. To log in through the AUX port, log in to the
device through the console port or another method, configure the password for AUX password
authentication or change the authentication mode, and configure related parameters.
Use the command...
ssh2 server
ssh2 ipv6 server
Figure
24, the console cable used in AUX port login is the same as that in console port login.
Remarks
Required
server is the IPv4 address or host name of the server.
Available in user view
Required
server is the IPv6 address or host name of the server.
Available in user view
.
33
- Quick Links:
- Firewall A-F1000
Hide quick links:
Advertisement
Table of Contents
