Configuring The Device To Log In To A Telnet Server As A Telnet Client; Logging In Through Ssh; Introduction - HP A-F1000-E Getting Started Manual
High-end firewalls
Hide thumbs
Also See for A-F1000-E:
- Product end-of-life disassembly instructions (3 pages) ,
- Installation manual (75 pages)
Table of Contents
Advertisement
Configuring the device to log in to a Telnet server as a Telnet
client
Configuration prerequisites
You have logged in to the device.
By default, you can log in to the device through the console port without authentication and have user
privilege level 3 after login. For information about logging in to the device with the default configuration,
see
"Configuration
Figure 21 Telnet from the firewall (Telnet client) to another device (Telnet server)
NOTE:
If the Telnet client port and the Telnet server port that connect them are not in the same subnet, make sure
that the two devices can reach each other.
Configuration procedure
Follow the step below to configure the device to log in to a Telnet server as a Telnet client:
To do...
Configure the device to
log in to a Telnet server
as a Telnet client
Specify the source IPv4
address or source
interface for sending
Telnet packets
Logging in through SSH
Introduction
Secure Shell (SSH) offers an approach to log into a remote device securely. By providing encryption and
strong authentication, it protects devices against attacks such as IP spoofing and plain text password
interception. The device supports SSH, and you can log in to the device through SSH to remotely manage
and maintain the device, as shown in
requirements."
Use the command...
telnet remote-host [ service-port ] [ source
{ interface interface-type interface-number
| ip ip-address } ]
telnet ipv6 remote-host [ -i interface-type
interface-number ] [ port-number ]
telnet client source { interface
interface-type interface-number | ip
ip-address }
Figure
22.
29
Remarks
Required
Use either command
Available in user view
Optional
By, no source IPv4 address or source
interface is specified. The source IPv4
address is selected by routing.
- Quick Links:
- Firewall A-F1000
Hide quick links:
Advertisement
Table of Contents
