Configuring Password Authentication For Telnet Login - HP A-F1000-E Getting Started Manual
High-end firewalls
Hide thumbs
Also See for A-F1000-E:
- Product end-of-life disassembly instructions (3 pages) ,
- Installation manual (75 pages)
Table of Contents
Advertisement
To do...
Specify the none authentication
mode
Configure the command level for
login users on the current user
interfaces
Configure common settings for
VTY user interfaces
When you log in to the device through Telnet again, perform the following steps:
You enter the VTY user interface, as shown in
•
If "All user interfaces are used, please try later!" is displayed, it means the current login users
•
exceed the maximum number. Please try later.
Figure 18 Configuration page
Configuring password authentication for Telnet login
Configuration prerequisites
You have logged in to the device.
By default, you can log in to the device through the console port without authentication and have user
privilege level 3 after login. For information about logging in to the device with the default configuration,
see
"Configuration
Configuration procedure
Follow these steps to configure password authentication for Telnet login:
To do...
Enter system view
Use the command...
authentication-mode none
user privilege level level
—
requirements."
Use the command...
system-view
Figure
18.
Remarks
—
23
Remarks
Required
By default, authentication mode for
VTY user interfaces is scheme.
Required
By default, the default command
level is 0 for VTY user interfaces.
Optional
See
"Configuring common settings
for VTY user interfaces
(optional)."
- Quick Links:
- Firewall A-F1000
Hide quick links:
Advertisement
Table of Contents
