Login Procedure - HP A-F1000-E Getting Started Manual
High-end firewalls
Hide thumbs
Also See for A-F1000-E:
- Product end-of-life disassembly instructions (3 pages) ,
- Installation manual (75 pages)
Table of Contents
Advertisement
Setting
Stop bits
Data bits
Login procedure
As shown in
1.
device. Plug the DB-9 connector of the console cable into the serial port of the PC, and plug the
RJ-45 connector into the console port of your device.
Figure 9 Connect the device and PC through a console cable
WARNING!
Identify interfaces correctly to avoid connection errors.
NOTE:
The serial port of a PC does not support hot-swap. Do not plug or unplug the console cable to or from the
PC when your device is powered on. To connect the PC to the device, first plug the DB-9 connector of the
console cable into the PC, and then plug the RJ-45 connector of the console cable into your device. To
disconnect the PC from the device, first unplug the RJ-45 connector and then the DB-9 connector.
Launch a terminal emulation program (such as HyperTerminal in Windows XP). The following
2.
takes the HyperTerminal of Windows XP as an example. Select a serial port to be connected to the
device, and set terminal parameters as follows: set Bits per second to 9600, Data bits to 8, Parity
to None, Stop bits to 1, and Flow control to None, as shown in
NOTE:
On Windows 7, Windows Vista, or some other operating system, obtain a third party terminal control
program first, and follow the user guide or online help of that program to log in to the device.
Figure
9, use the console cable shipped with the device to connect the PC and the
Default
1
8
11
Figure 10
through
Figure
12.
- Quick Links:
- Firewall A-F1000
Hide quick links:
Advertisement
Table of Contents
