Commissioning Measuring Cycles, Hmi-Embedded Tcu Solution Line Sw 1.X; Requirements; Step 1 - Load Archive - Siemens SINUMERIK 840D sl Programming Manual
Measuring cycles
Hide thumbs
Also See for SINUMERIK 840D sl:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Advertisement
10.6
Commissioning measuring cycles, HMI-Embedded TCU solution line
10.6
SW 1.x
10.6.1
Requirements
The software release of the measuring cycles to be started up must be present on the CF
card.
Up to NCK 63.xx.xx, the following machine data from steps 0.1 and 0.2 from chapters 10.2.2
and 10.2.3 should be checked:
• MD18130: MM_NUM_GUD_NAMES_CHAN
• MD18180: MM_NUM_MAX_FUNC_PARAM
• MD11420: LEN_PROTOCOL_FILE
• MD28082: MM_SYSTEM_FRAME_MASK
10.6.2
Step 1 – load archive
Load the archive files needed:
In the "Services" area, softkey "Program data", use the cursor keys to change to "Cycle
storage" and use the Input key to open.
In the "Cycle storage" area, use the cursor keys to change to "Measuring cycles" and use
the Input key to open. Load the archive files needed using the 1st vertical softkey "Load
archive". It should be noted that the archive files have to be selected and loaded individually.
Once all the archive files needed have been loaded, an NC reset should be run via the
operating area "Commissioning" softkey "NC reset".
Measuring cycles
Programming Manual, Release 04/2006, 6FC5398-4BP10-0BA0
10.6 Commissioning measuring cycles, HMI-Embedded TCU solution line SW 1.x
CYCCUST_GR.ARC
CYCCUST_UK.ARC
MCYCLES.ARC
MCYCMILL.ARC
MCYCTURN.ARC
DEFINES.ARC
JOGMCYC.ARC
Archive for user cycles German
Archive for user cycles English
Archive with all measuring cycles (milling and turning)
Archive with all milling measuring cycles
Archive with all turning measuring cycles
Archive with definition files (GUD5.DEF, GUD6.DEF,
GUD7_MC.DEF)
Archive with all measuring cycles for measuring in JOG
Start-up (hardware)
10-19
Advertisement
Table of Contents
