Siemens SINUMERIK 840D sl Programming Manual page 131
Measuring cycles
Hide thumbs
Also See for SINUMERIK 840D sl:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Advertisement
Proceed as follows
Approaching the tool measuring probe
Position the calibration tool roughly over the center of the measuring surface of the tool
probe.
Select the function with softkey
Continue with
In the input screen form, select the type of calibration by pressing the "alternative" softkey.
• Calibrate length only:
or
• Calibrate length and diameter:
Result
On "NC start", calibration runs automatically with the measuring feed entered in
_E_MESS_MT_FM in data block GUD7.
The current distance dimensions between the machine zero and tool probe (trigger points)
are determined using the calibration tool and stored in a data area.
The tool probe is now prepared for measurement of tools.
Measuring cycles
Programming Manual, Release 04/2006, 6FC5398-4BP10-0BA0
z
x
z
x
Measuring in JOG
4.3 Measuring the tool
4-43
Advertisement
Table of Contents
