Siemens SINUMERIK 840D sl Programming Manual page 137

Measuring cycles

Hide thumbs Also See for SINUMERIK 840D sl:

Table of Contents

• When using a multidirectional probe the best measurement results are achieved if, during

• The G functions active before the measuring cycle is called remain active after the

• Measurements must always be performed under the same conditions as applied when

Measuring cycles

Programming Manual, Release 04/2006, 6FC5398-4BP10-0BA0

calibration and measurement, the probe in the spindle is mechanically oriented to have

one and the same point on the probe ball point, for example, in the + direction of the

abscissa (+X with active G17) in the active workpiece coordinate system.

measuring cycle call, even if they have been changed inside the measuring cycle.

the probe was calibrated.

Measuring cycles from measuring cycles SW 6.2 and higher can only be used with NCK-

SW 6.3 and higher.

Measuring Cycles for Milling and Machining Centers

5.1 General prerequisites