Table of Contents
Advertisement
7
Alarm and Warning Reporting
58
Item
Recorder status
Recording made
Fault number
Memory used
Pre-trigger time
Post-trigger time
Maximum record
time
Retrigger enabled
Sample rate
Inhibition time
Inhibition count
Inhibition window
*This information is 1 when record is generated and 0 during the record generation.
**The counter restarts when the equipment reboots or a new configuration is sent.
***Parameter configured in configuration tab Recording> Disable for.
The DR60 can report alarm/warning using the dry contact normally closed relay or via
communication protocols (MMS and GOOSE).
The alarm events, in addition to the protocol transmission, will also operate the IN
SERVICE normally closed dry contact relay.
Warning events can only be sent via protocol.
The table also presents the IEC 61850 data name/address to be used when creating a
dataset for these alarms/warnings.
Alarms
Sync NOT OK
Shows if the respective recorder is enabled or disabled
Shows that a trigger was generated*
Shows how many triggers were generated**
Shows the percentage usage of the respective recorder
Shows the pre-trigger time configured
Shows the post-trigger time configured
Shows the maximum recorder time configured
Shows if the retrigger is enabled or disabled
Shows the configured sampling rate for the respective
recorder
Shows the duration that the trigger generation will be
disabled***
Shows how many consecutive triggers within the inhibition
time window are needed to enable the trigger inhibition***
Shows the time that is needed to enable the trigger
inhibition***
Data Name
BSE/ALARMSGGIO1.ST.Alm1
Description
Description
DR60-TM-EN-2A
DR60
- Quick Links:
- Dr60 Configurator Tool
Hide quick links:
Advertisement
Table of Contents
