Mds 4790/9790 Simplex Radios-With Antenna Switch Modules; Mds 4790/970-Front End Helical Coil Alignment; Testing And Removing An Internal Duplexer; Testing - GE MDS 4790 Series Installation & Operation Manual

400 mhz/900 mhz multiple address system master station radio
Table of Contents

Advertisement

MDS 05-3438A01, Rev. F
RSPSupply - 1-888-532-2706 - www.RSPSupply.com
http://www.RSPSupply.com/p-8457-MDS-UP-9790X.aspx
MDS 4790/9790 Simplex Radios—With Antenna
Switch Modules
Simplex radios do not have a duplexers. In its place, an Antenna Switch
Module is placed to switch the antenna system between the radio's
transmitter and receiver. The switch does not have any frequency-sensi-
tive elements and covers the radio's entire operating band. You can pro-
gram radios equipped with this module to any frequency within their
operating range. However, two things must be considered:
1. The antenna system's performance might not be satisfactory on the
new frequency. You can quickly check this by measuring the
antenna system's standing-wave-ratio (SWR) for a ratio of 1.5:1 or
less at the antenna.
2. The receiver's front-end helical coils will need retuning if the
change in receive frequency is more than 5 MHz.
Figure 44. Antenna Switch Module
MDS 4790/970—Front End Helical Coil Alignment
Changing the radio's receive frequency by more than 5 MHz requires
re-alignment of the receiver's front-end helical coil set. Significant deg-
radation in receive bit-error rate (BER) is likely if the coils are not
aligned properly. For assistance, contact GE MDS Technical Support
for details about the tuning procedure.

8.5 Testing and Removing an Internal Duplexer

Testing

If you suspect that the internal duplexer is not functioning properly, per-
form the following steps to determine if requires replacement:
1. Measure the RF power out of the antenna jack.
If the power registers approximately +37 dBm (5 watts), the internal
duplexer is probably functioning correctly (see
for dBm-volts-watts conversion chart).
If the power registers significantly less than +37 dBm, proceed with
Step 2.
2. Open the radio chassis, locate the TX cable, and disconnect the
cable from vertical interface board
MDS 4790/9790 Series I/O Guide
Table 21 on Page 103
(Figure 45 on Page
92).
91

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents