Soft-Carrier Dekey
Serial Number
Show Selected
Parameters
54
RSPSupply - 1-888-532-2706 - www.RSPSupply.com
http://www.RSPSupply.com/p-8457-MDS-UP-9790X.aspx
Entering the
command without a parameter displays the timer
RXTOT
value in minutes. Entering the
ranging from 1 to 1440 resets the timer in minutes. Entering the
command with the parameter
is
.
NONE
SCD [0-255]
The "soft-carrier dekey" command sets or displays the amount of time
to wait after a de-key request before actually de-keying the radio's trans-
mitter.
Entering the
command without a parameter displays the timer value
SCD
in milliseconds. Entering the
from 0 to 255 resets the timer in milliseconds. The default setting is 0,
which means that the radio de-keys immediately following removal of a
keying signal
(see "Simplex and Switched Carrier Operation" on
Page
4).
If you experience problems with repeater operation after changing the
,
or
values, contact GE MDS Technical Support.
CTS
PTT,
SCD
SER
This command displays the radio's serial number as recorded at the fac-
tory.
SHOW [DC/PWR/CURRENT/RADIO]
The
command discloses different types of radio information,
SHOW
depending on the command parameter entered. These are:
•
—Displays DC input/output voltages.
DC
•
—Displays the actual (measured) RF power output in dBm.
PWR
Unlike the
PWR
measured, not the programmed RF power setting.
•
—Shows the low noise amplifier and total board cur-
CURRENT
rent.
•
—Shows the currently active radio (A or B).
RADIO
MDS 4790/9790 Series I/O Guide
command with a parameter
RXTOT
disables the timer. The default value
NONE
Transmit Timeout
A
B
Page 71
command with a parameter ranging
SCD
Serial Number
A
B
command, this command shows the actual level
MDS 05-3438A01, Rev. F
RXTOT
screen,
screen,
Page 78