Table of Contents
Advertisement
Set Time
S e t T i m e
1 2 : 0 4 : 0 3 A M
M a y 0 1 1 9 9 9
Set Date
S et D a t e
1 2 : 0 4 : 0 3 A M
M a y 0 1 1 9 9 9
GROUP 3—DIAGNOSTICS
Operating Status
O p e r a t i n g S t a t u s
T X : d e k e y e d
R S S I : - 6 0 d B m
S / N 1 0 d B
Active Radio
Status
A c t i v e R a d i o S t a t u s
A l a r m s p r e se n t
( e n t e r f o r d e t a i l s )
E v e n t : 2 0 ( M I N O R )
C o n f i g u r a t i o n e r r o r
Receive Signal
Strength
R x S i g n a l S t r e n g t h
- 1 2 0 d B m
MDS 05-3438A01, Rev. F
RSPSupply - 1-888-532-2706 - www.RSPSupply.com
http://www.RSPSupply.com/p-8457-MDS-UP-9790X.aspx
Use this screen to set or show the time set in the radio. The accuracy of the date
and time are important, because events are logged with the date and time.
To change the time, press ENTER, then use the left/right arrow buttons to select
the hour, minute, second, or AM/PM. Then use the up/down arrow buttons to
increase or decrease the digit, or toggle between AM and PM. Repeat for other
characters if necessary. Press ENTER again to make the change.
Use this screen to set or show the date set in the radio. The accuracy of the date
and time are important because events are logged with the date and time.
To change the date, press ENTER, then use the left/right arrow buttons to select
the month, day, or year. Then use the up/down arrow buttons to increase or
decrease the day or year, or set the month. Repeat for other characters if
necessary. Press ENTER again to make the change.
This screen displays three key operating conditions of the radio: TX key status,
Received Signal Strength Indication (RSSI), and Signal-to-Noise (S/N) ratio. Unlike
other screens, the information shown on the Operating Status screen is preserved
across power outages and radio switchovers. This screen has no timeout and will
show until changed by an operator.
Use this screen to show alarm conditions, if any. Major and minor alarm events are
listed in
Table 13 on Page
57.
If there have been alarm events, press ENTER to show the first alarm. To scroll
through the list of alarms, press the right
ESCAPE returns the radio to the Active Radio Status screen.
This screen displays the received signal strength in dBm.
In a typical master station configuration, the received signal strength is read from
each remote radio that transmits to the master station.
MDS 4790/9790 Series I/O Guide
TIME [hh:mm:ss]
command,
Page 57
DATE [mmm dd yyyy]
command,
Page 44
or down
arrow button. Pressing
STAT
command,
Page 56
RSSI, RSSI!
command,
Page 52
77
Hide quick links:
Advertisement
Table of Contents
