Connection
5.2 Electric
Preparing the positioner
1. You have performed the steps described in the section "General information on installing
option modules (Page 48)".
2. Unplug the ribbon cable connector
electronics
3. Remove the basic electronics
that fix the basic electronics to the pneumatic block.
4. Loosen screw
5. Insert the connector of the ribbon cable (A) into the slot as shown below.
6. Secure the EMC filter module using the screw
7. Fit the basic electronics
8. Insert the ribbon cable connector
electronics.
9. In non-hazardous environment:
– Stick the supplied nameplate over the nameplate on the external position detection
– Replace the blue cable gland
Refer to section "Scope of delivery of external position detection system (Page 270)", items
"Nameplate for device version without explosion protection" and "Gray cable gland".
For further information on fitting of an option module, refer to the operating instructions of the
respective positioner version in section "Installing/mounting > Installing option modules".
Procedure for connecting an external position detection system
1. Connect the three terminals of the external position detection system
terminals of the EMC filter module
2. Tighten the cable glands
See also
Installing optional modules in the standard and intrinsically safe version (Page 49)
94
⑤
.
⑥
in the connection area of the positioner.
⑤
⑧
system
.
⑩
④
to the fitted potentiometer from the basic
⑤
from the positioner. To this end, remove the two screws
⑥
loosened in the third step.
back into the positioner.
④
of the EMC filter module onto the positioner basic
⑩
by the supplied gray cable gland.
①
using a cable as shown in the wiring diagram.
⑫
and
.
Operating Instructions, 09/2014, A5E00074631-12
⑨
to the three
SIPART PS2 with and without HART