Table of Contents
Advertisement
Initializing the positioner manually
1. Switch to the "Configuration" mode. To do this, press the
until the display shows the following:
2. Set the "YFCT" parameter to "turn". To do this, press
following:
3. Call the second parameter "YAGL". To do this, press
following:
4. Call the "INITM" parameter. To do this, press the
following:
5. Start the initialization process. Press the
shows the following:
6. The current potentiometer position is output on the display after 5 seconds:
7. Determine the lower endstop of the actuator.
8. Move the actuator to the desired position using the
SIPART PS2 with and without HART
Operating Instructions, 09/2014, A5E00074631-12
7.6 Commissioning part-turn actuators
button for at least 5 seconds
. The display shows the
. The display shows the
button twice. The display shows the
button for at least 5 seconds until the display
or
button.
Commissioning
135
Advertisement
Table of Contents
