GE ApexPro Service Manual page 80
Telemetry server
Hide thumbs
Also See for ApexPro:
- Operator's manual (218 pages) ,
- Service manual (202 pages) ,
- Manual (28 pages)
Table of Contents
Advertisement
Configuration
5-12
Parameter
System ID
Identifies the system to the GE
backoffice servers.
Serial Number
Identifies the unit and is set at the
time of manufacture.
Enterprise URL
If required, designate the address
of the GE backoffice servers
required to communicate with the
Remote Service agent.
Enterprise Tunnel
If required, designate the address
URL
of the GE backoffice servers
required to communicate with the
tunneling agent.
Protocol
Identifies the protocol used to
communicate with the enterprise
servers.
5.
Select Save to apply the configuration setting changes.
Enable the Remote Service agent
The ATS is factory-configured with the Remote Service agent disabled. After an FE
has configured your ATS for remote serviceability, this option must be enabled for
use. To enable or disable the Remote Service agent, perform the following steps.
1.
Log onto the Webmin service interface on page
2.
Select the Configuration tab.
3.
Select Remote Service > Control.
4.
On the Remote Service Controls screen, select the appropriate option in the New
State field:
To enable the Remote Service Agent, select Enable.
ApexPro™ Telemetry
Remote Service Configuration
Value
4-7.
Notes
These values are read-only
and are unique.
This address is typically
preconfigured to connect to the
Remote Back Office, but it can
be edited to suit customer
requirements.
This field is read-only and
cannot be changed.
125A
2001989-203C
Advertisement
Chapters
Table of Contents
Troubleshooting
