Drive Bay - GE ApexPro Service Manual
Telemetry server
Hide thumbs
Also See for ApexPro:
- Operator's manual (218 pages) ,
- Service manual (202 pages) ,
- Manual (28 pages)
Table of Contents
Advertisement
Parts lists, drawings and replacement
Drive bay
7-16
9.
Perform steps
2-5
in reverse order to reseat the SNMP Extension board.
CAUTION
EQUIPMENT DAMAGE— Use extra care to make sure the pins
are properly aligned before seating the SNMP extension board.
Bent/broken pins may result if the pins are misaligned.
1.
Complete the preparation procedures.
7-3.
2.
Remove the chassis cover.
3.
Using a phillips screwdriver, remove the 2 screws securing the inside edge of the
drive bay to the bottom of the chassis.
4.
Using a phillips screwdriver, remove the 2 screws securing the outside edge of
the drive bay to the right side of the chassis.
5.
Disconnect the connector from the back of the temperature sensor located along
the left edge of the CD/top hard drive carrier.
ApexPro™ Telemetry
See Field replacement preparation on page
See Chassis cover on page 7-6.
185A
016A
017A
2001989-203C
Advertisement
Chapters
Table of Contents
Troubleshooting
