Table of Contents
Advertisement
user-configurable. It is possible to assign one signal or up to six ANDing or ORing signals to one
output relay. Available signals are listed in Appendix B.
It is also possible to attach a drop-off delay time of 0.2 second to these signals. The drop-off
delay time is disabled by the scheme switch [BOTD].
Appendix D shows the factory default settings.
To configure the binary output signals, do the following:
Selection of output module
• Press 8 (=Binary output) on the "Setting (change)" screen to display the "Binary output"
screen. The available output module(s) will be shown. (This differs depending on the relay
model.)
/ 2
B i n a r y
1 = I O #
2
• Press the number corresponding to the selected output module to display the "Binary output"
screen.
/ 3
B i n a r y
S e l e c t
Note: The setting is required for all the binary outputs. If any of the binary outputs are not to be
used, enter 0 for logic gates #1 to #6 when assigning signals.
Selecting the output relay
• Enter the output relay number and press the ENTER key to display the "Setting" screen.
/ 4
S e t t i n g
1 = L o g i c
2 = I n p u t
Setting the logic gate type and timer
• Press 1 to display the "Logic gate type & delay timer" screen.
/ 5
L o g i c
L o g i c
B O T D
• Enter 1 or 2 to use an OR gate or AND gate and press the ENTER key.
• Enter 0 or 1 to add 0.2s off-delay time to the output relay or not and press the ENTER key.
• Press the END key to return to the "Setting" screen.
Assigning signals
• Press 2 on the "Setting" screen to display the "Input to logic gate" screen.
o u t p u t
2 = I O #
3
o u t p u t
B O
(
g a t e
t y p e
&
d e l a y
t o
l o g i c
g a t e
g a t e
t y p e
&
1 = O R
2 = A N D
0 = O f f
1 = O n
223
3 = I O #
4
( * * * * * )
1 -
* * )
S e l e c t
N o . =
( B O * *
o f
* * * * * )
t i m e r
d e l a y
t i m e r
6 F 2 S 0 8 5 0
1 /
2
1
1
- Quick Links:
- Current Differential Protection
Hide quick links:
Advertisement
Table of Contents
