Reactivating A Tool - Siemens SINUMERIK 840D sl Operating Manual
Hide thumbs
Also See for SINUMERIK 840D sl:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Advertisement
Tool management
11.6 Tool wear
Icon/
Marking
Yellow triangle pointing
upward
Green border
Magazine/location number
Green double arrow
Gray double arrow
(configurable)
Red "X"
Procedure
See also
Changing a tool type (Page 246)
11.6.1
Reactivating a tool
You can replace disabled tools or make them ready for use again.
Preconditions
In order to reactivate a tool, the monitoring function must be activated and a setpoint must be
stored.
Procedure
236
1.
Select the "Parameter" operating area.
2.
Press the "Tool wear" softkey.
1.
The tool wear list is opened.
2.
Position the cursor on the disabled tool which you would like to reuse.
3.
Press the "Reactivate" softkey.
The value entered as the setpoint is entered as the new tool life or work‐
piece count.
The disabling of the tool is canceled.
Meaning
The tool is in a special state.
Place the cursor on the marked tool. A tooltip provides a
short description.
The tool is preselected.
The magazine location is positioned at the change position.
The magazine location is positioned at the loading position.
The magazine location is disabled.
Operating Manual, 05/2017, A5E40868517
Universal
Advertisement
Table of Contents
