Tool List - Siemens SINUMERIK 840D sl Operating Manual
Hide thumbs
Also See for SINUMERIK 840D sl:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Advertisement
Note
An electronic workpiece probe must be calibrated before use.
11.5
Tool list
All parameters and functions that are required to create and set up the tools are displayed in
the tool list.
Each tool is uniquely identified by the tool identifier and the replacement tool number.
Tool parameters
Column heading
Location
BS
* If activated in magazine
selection
Type
Tool name
Universal
Operating Manual, 05/2017, A5E40868517
Machine manufacturer
The tool length of the workpiece probe is measured to the center of the ball
(length m) or to the ball circumference (length u).
Please refer to the machine manufacturer's specifications.
Meaning
Magazine/location number
● The magazine location numbers
The magazine number is specified first, followed by the location number
in the magazine.
If there is only one magazine, only the location number is displayed.
● Load position in the load magazine
The following icons can also be displayed for other magazine types (e.g.
for a chain):
● Spindle location as an icon
● Locations for gripper 1 and gripper 2 (applies only when a spindle with
dual gripper is used) as icons.
Tool type
Specific tool offset data is displayed depending on the tool type (represen‐
ted as an icon).
You have the option of changing the tool type using the <SELECT> key.
The tool is identified by the name and the replacement tool number. You
may enter the names as text or numbers.
Note: The maximum length of tool names is 31 ASCII characters. The num‐
ber of characters is reduced for Asian characters or Unicode characters.
The following special characters are not permitted: | # ".
Tool management
11.5 Tool list
221
Advertisement
Table of Contents
