Simulating machining
7.6 Editing the simulation display
7.5.4
Side view
Displaying further side views
Changing the display
You can increase or decrease the size of the simulation graphic and move it, as well as change
the segment.
7.6
Editing the simulation display
7.6.1
Blank display
You have the option of replacing the blank defined in the program or to define a blank for
programs in which a blank definition cannot be inserted.
Note
The unmachined part can only be entered if simulation or simultaneous recording is in the
reset state.
180
1.
Simultaneous recording or the simulation is started.
2.
Press the "Other views" softkey.
3.
Press the "From front" softkey if you wish to view the workpiece from the
front.
- OR -
Press the "From rear" softkey if you wish to view the workpiece from the
rear.
- OR -
Press the "From left" softkey if you wish to view the workpiece from the
left.
- OR -
Press the "From right" softkey if you wish to view the workpiece from the
right.
Operating Manual, 05/2017, A5E40868517
Universal