Table of Contents
Advertisement
Code
Command explanation
Delete trace in MMC
73
The recorded data (trace function) stored in the
Micro Memory Card are deleted.
74
Delete trace in RAM
The stored data (trace function) in the RAM
memory are deleted.
75
Format MMC
The Micro Memory Card parameters are defined
corresponding with the definitions in the module data.
All of the stored content in the MMC is deleted.
Delete all MMC data (log data, measurement
76
data, ...)
The data stored in the Micro Memory Card are
deleted.
77
Trace Single recording
The instruction causes a single recording of a trace
element. The time intervals between two trace
recordings do not require a fixed definition. With a
trace to MMC, renewed trace instructions will only
lead to a new trace recording after 50 ms. With
tracing to RAM, the recording is executed within
max. 10 ms.
Scale commands
Start weighing with tare zero setting mode
100
Start weighing with previous zero setting or taring
corresponding with the setting for tare / zero setting
mode.
101
Start weighing without tare zero setting mode
Start weighing without zero setting or taring. This is
only permitted in non-calibratable operation
(country code not "OIML").
Start continuous weighing
102
Continuous start of sequential weighing cycles.
(Only possible in operating AWI mode)
SIWAREX FTA
Commands
Executable
in following
operating
states
All
All
Service
operation
Service
operation
No weighing
cycle, No
service
No weighing
cycle, No
service
No weighing
cycle, No
service
6-131
Advertisement
Table of Contents
