Table of Contents
Advertisement
Weighing Functions
5.10.1 DR 16 - Weight simulation entry
If the DR 16 has been defined as the source for the weight simulation (see
DR 7
Source for the weight
SIWAREX FTA is deactivated by defining a weight value with the DR 16 and the
defined value is "simulated" as a weight value. This way, system components can
be tested although the scale is not yet completely constructed.
5.11 DR 17 Analog Output Control (NAWI, AWI)
If DR17 has been defined as the source for the analog output (see DR 7
the analog
stream on the analog output.
Procedure:
o
Check for whether DR 17 has been defined as the source for the analog output
in DR 7
o
Check the parameter definition of the analog output (see DR 7
point and following
o
Enter value in DR 17
o
Send DR 17 to the scale
Name
Analog output
Ext. Definition for analog
output
Table 5-10
DR 17 Allocation
5.11.1 DR 17 - Ext. Definition for Analog Output
If the DR 17 has been defined as the source for controlling the analog output (see
DR 7 - Source for the Analog
defined value with a definition of a weight value on DR 17. This way, the analog
output can be set via SIWATOOL.
5.12 DR 18 Control Display (NAWI, AWI)
A value can be defined through DR18 which is to be shown on the remote display.
This way, the SIEBERT remote display can be used for displaying values that are
calculated in the SIMATIC.
Procedure:
o
Enter value in DR 18
o
Send DR 18 to the scale
5-90
simulation) then the measurement input of the
output) then sending a weight value will output a corresponding output
parameters).
Type
Address
Default
REAL
DBD000
0
4
Output) then the analog output is controlled with the
Range of Values / Explanation
Analog output control with a default
value.
Source for
Weight for zero
Reference
5.11.1
SIWAREX FTA
Advertisement
Table of Contents
