Lsr-Id - HP FlexFabric 12500 Command Reference Manual

Routing switch series, mpls
Table of Contents

Advertisement

Examples
# Configure an LSP generation policy to use only routes 10.10.1.0/24 and 10.20.1.0/24 to establish LSPs
for the public network.
<Sysname> system-view
[Sysname] ip prefix-list egress-fec-list index 1 permit 10.10.1.0 24
[Sysname] ip prefix-list egress-fec-list index 2 permit 10.20.1.0 24
[Sysname] mpls ldp
[Sysname-ldp] lsp-trigger prefix-list egress-fec-list
Related commands
ip prefix-list (Layer 3—IP Services Command Reference)

lsr-id

Use lsr-id to configure an LDP LSR ID.
Use undo lsr-id to delete the configured LDP LSR ID.
Syntax
lsr-id lsr-id
undo lsr-id
Default
No LDP LSR ID is configured. LDP uses the MPLS LSR ID configured by the mpls lsr-id command for both
the public network and VPN instances.
Views
LDP view, LDP-VPN instance view
Predefined user roles
network-admin
mdc-admin
Parameters
lsr-id: Specifies an LDP LSR ID, in dotted decimal notation.
Usage guidelines
If you configure an LDP LSR ID by using the lsr-id command in LDP view or LDP-VPN instance view, LDP
uses the LDP LSR ID. Otherwise, LDP uses the LSR-ID configured by the mpls lsr-id command.
LDP uses the same LSR ID for all sessions in the same VPN instance. After you configure a new LSR ID for
a VPN instance, LDP does not use the new LSR ID unless you use the reset mpls ldp command to
reestablish all LDP sessions in the VPN instance.
For the public network, HP recommends that you use the default LDP LSR ID configured by the mpls lsr-id
command. If you want to configure an LDP LSR ID for the public network by using the lsr-id command,
specify the IP address of a local Loopback interface as the LDP LSR ID for high reliability.
Examples
# Configure the LDP LSR ID as 2.2.2.2 for the public network.
<Sysname> system-view
[Sysname] mpls ldp
46

Advertisement

Table of Contents
loading

This manual is also suitable for:

Flexfabric 12500e

Table of Contents