Mpls Mtu - HP FlexFabric 12500 Command Reference Manual
Routing switch series, mpls
Hide thumbs
Also See for FlexFabric 12500:
- Configuration manual (402 pages) ,
- Network management and monitoring command reference (320 pages) ,
- Command reference manual (154 pages)
Table of Contents
Advertisement
Default
An LSR has no LSR ID.
Views
System view
Predefined user roles
network-admin
mdc-admin
Parameters
lsr-id: Specifies an ID for identifying the LSR, in dotted decimal notation.
Usage guidelines
HP recommends that you use the address of a loopback interface on the LSR as the LSR ID.
Examples
# Configure the LSR ID as 3.3.3.3 for the local node.
<Sysname> system-view
[Sysname] mpls lsr-id 3.3.3.3
Related commands
lsr-id
mpls mtu
Use mpls mtu to configure the MPLS MTU for an interface.
Use undo mpls mtu to restore the default.
Syntax
mpls mtu value
undo mpls mtu
Default
The MPLS MTU of an interface is not configured. Fragmentation for MPLS packets is based on the MTU
of the interface, and the length of a fragment does not include that of the MPLS label. Thus, after an MPLS
label is added into a fragment, the length of the MPLS fragment might exceed the interface MTU.
Views
Interface view
Predefined user roles
network-admin
mdc-admin
Parameters
value: Specifies the MPLS MTU of the interface, in the range of 46 to 65535 bytes.
Usage guidelines
This command is effective only when MPLS is enabled on the interface.
17
Advertisement
Table of Contents
