Sony DVS-9000 User Manual page 92
With ccp-8000 series center control panel
Hide thumbs
Also See for DVS-9000:
- User manual (1072 pages) ,
- Installation manual (42 pages) ,
- Operation manual (24 pages)
Table of Contents
Advertisement
WIPE: The current video is replaced by the
new video, using the wipe pattern
selected in the Wipe menu.
DME: This applies a wipe-like transition,
using the DME effect selected in the
DME Wipe menu.
FM1&2CLIP, FM3&4CLIP,
FM5&6CLIP, FM7&8CLIP: A
recorded clip is played back together
with the transition. At this point, you
can also carry out a background
transition (wipe or mix (dissolve))
simultaneously together with the clip.
KF (key frame): Press this button, turning
it on, to enable using the fader lever as
a key frame fader.
b Key transition selection buttons
To insert or delete key 1 on the next
transition, hold down the [KEY1] button,
and select the type of transition using the
transition type selection buttons. If the key
is currently not inserted, the transition will
insert it, and if the key is currently inserted,
the transition will delete it. You can use the
[KEY2] button in a similar way.
While these buttons are held down, you can
select a key source with the cross-point
buttons on the key bus.
Pressing one of these buttons twice in rapid
succession changes the state of the
corresponding key bus so that a cross-point
can be selected.
Key delegation button
(double press)
[KEY1]
[KEY2]
a) The key bus switching button [KEY3] in the cross-
point control block goes off.
b) The key bus switching button [KEY4] in the cross-
point control block goes off.
92
Names and Functions of Parts of the Control Panel
c Transition execution section
Fader lever: Move this vertically to carry
Transition indicator: This comprises
Transition rate display: This displays the
TAKE button: Pressing this button carries
d Wipe direction selection buttons
For details, see "Wipe direction selection
Corresponding
buttons" (page 59).
key bus
a)
key 1
e Pattern limit buttons
b)
key 2
LIMIT SET: Move the fader lever to the
PTN (pattern) LIMIT: When a wipe or
out a transition.
When the [KF] button or a transition
type selection button to which the KF
button function has been assigned is lit,
you can use this as a key frame fader.
When the split fader function is
enabled, by pressing the projection on
the left side of the grip you can release
the lock and separate the two halves of
the fader lever. With the split fader
lever, in a background mix transition,
you can control the background A and
B buses independently.
multiple LEDs, which show the
progress of the transition.
transition rate (the time from the
beginning of the transition to its
completion) set for an auto transition,
in frames.
You can set the transition rate using the
numeric keypad control block or menu.
out an auto transition of the set
transition rate. The transition starts
immediately, and the button lights
amber. When the transition completes,
the button goes off.
position of a particular pattern size, and
stop it there, then press this button to
set the pattern limit range. This button
is enabled when the [PTN LIMIT]
button is off.
DME wipe is selected, pressing this
Advertisement
Table of Contents
