Executing A Macro By Macro Attachment - Sony DVS-9000 User Manual

With ccp-8000 series center control panel

Hide thumbs Also See for DVS-9000:

Table of Contents

Executing a Macro by Macro Attachment

For execution on any of the M/E and PGM/PST banks, use the [MCRO

ATTCH ENBL] button in the cross-point control block. To execute a macro

according to a macro attachment set elsewhere, assign "MCRO ATTCH

ENBL" to a utility/shotbox control block or user preference button, then use

that button.

Executing a macro assigned to a button

Depending on the location of the button you want to use, press the [MCRO

ATTCH ENBL] button, turning it on.

Press the desired button for which a macro attachment has been set.

This recalls the macro register assigned to the button, and the macro is

executed as follows, according to the operation mode.

Pre macro mode: The macro is executed first, and then the button

function is executed.

Post macro mode: The button function is executed first, and then the

macro is executed.

Macro only mode: The button function is not executed, and the macro

only is executed.

During macro execution, the button you pressed flashes.

• It is not possible to execute more than one macro at a time. Therefore, even

if you simultaneously press multiple buttons for which macro attachments

are set, only one macro is executed.

• During macro execution, recalling the same register again stops the macro

being executed. Therefore, pressing twice a button for which a macro

attachment is set stops the macro being executed.

• Individual events stored in a macro are executed according to the settings in

setup. If you change the settings in setup, a saved macro may not have the

expected effect.

• During macro execution, if you switch the control panel to macro editing

mode, the macro being executed stops.

Macro attachment settings scrolling

Setting values

1 and upwards

Macro Attachment Assigning