Sony DVS-9000 User Manual page 69
With ccp-8000 series center control panel
Hide thumbs
Also See for DVS-9000:
- User manual (1072 pages) ,
- Installation manual (42 pages) ,
- Operation manual (24 pages)
Table of Contents
Advertisement
[M/E1] to [M/E3]: DEV1 (device 1) to
DEV3 (device 3)
[P/P]: DEV4 (device 4)
[USER]: FM1CLIP (frame memory
clip 1)
[Unused]: FM2CLIP (frame memory
clip 2)
[DME1] to [DME4]: DEV5 (device 5)
to DEV8 (device 8)
[Unused]: FM LOOP (frame memory
loop)
[DME5] to [DME8]: DEV9 (device 9)
to DEV12 (device 12)
To exit from this mode, press the
[DEV] button again, turning it off.
When the [RUN CTRL] button is
selected: This enables the effect run
control mode in the device control
block.
[RSZR CTRL] button: Cannot be used.
The functions of the operation buttons,
trackball, and Z-ring vary with the
operation mode as follows.
b Operation buttons
When the positioner operation mode is
enabled
K1 CB1: Press this button to enable wipe
pattern position setting for key 1
(DSK1).
When the [USER] button is selected,
pattern position setting for color
background 1 is enabled.
K2 CB2: Press this button to enable wipe
pattern position setting for key 2
(DSK2).
When the [USER] button is selected,
pattern position setting for color
background 2 is enabled.
K3: Press this button to enable wipe pattern
position setting for key 3 (DSK3).
K4: Press this button to enable wipe pattern
position setting for key 4 (DSK4).
MAIN: Press this button to enable main
wipe pattern position setting for normal
transitions.
SUB: Press this button to enable sub wipe
pattern position setting for normal
transitions.
Among the [K1 CB1] button, [K2 CB2]
button, [K3] button, [K4] button, [MAIN]
button, and [SUB] button, you can select
multiple buttons.
POS: Press this button to enable pattern
movement in the x-axis and y-axis
directions with the trackball.
When the [USER] button is selected,
this enables the trackball to move the
pattern in the x-axis and y-axis
directions, and the Z-ring to adjust the
size of the pattern.
X, Y: These restrict the axes affected by the
trackball and Z-ring to the x- or y-axis.
Z: This restricts the axes affected by the
trackball and Z-ring to the z-axis.
CTR (center): When this button is pressed,
the pattern position returns to the
center. When the [USER] button is
selected, the pattern size also returns to
50.00.
SHIFT/CLR WORK BUFR: Press this
button twice in rapid succession to
reset all parameters on the target M/E
or PGM/PST to their initial values.
When the three-dimensional transform
operation mode is enabled
The Buttons are used for three-dimensional
DME transformations.
For details, see "Basic Operations" in
Chapter 11 (Volume 2).
When the VTR/disk recorder/frame
memory operation mode is enabled
The Buttons are used for VTR control or
playback of frame memory clips.
Names and Functions of Parts of the Control Panel
69
Advertisement
Table of Contents
