Table of Contents
Advertisement
３ Remove the thermistor connector.
Red wire
４ Take the used thermistor out from the coupling, and then replace it with the new one.
５ Attach the new banding band and the packing, and then reassemble all the removed
parts in reverse order of the procedures above.
[Cautions]
(1) When attaching new packing, peel off the paper liner first, and then apply the packing around the
bundle of wires and tubes.
(2) When reassembling the removed parts, be sure NOT to pinch any wires.
(3) When attaching the new banding band and the new packing, be sure to the points described in the
figure below.
[UX-D, B]
[UX-E]
Make the knot of a binding band
an opposite angle
Refer to these figures when attaching the banding band
and the packing(s) for their locations and directions.
.
5-18
White wire
Used thermistor
New thermistor
Attach the packing(s) and the banding band
referring to the mark on the tube, which is put in
２.
procedure
- Quick Links:
- Troubleshooting List
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
Related Manuals for Hitachi IJ UX
Related Products for Hitachi IJ UX
- Hitachi IJ PH
- Hitachi IJ RX2
- Hitachi IJ UX2
- Hitachi IPJ-AW250N
- Hitachi Innovate iPJ-AW250NM
- Hitachi IC25N040ATCS04-0 - Travelstar 40GN 40GB UDMA/100 4200RPM 2MB 2.5" IDE Hard Drive
- Hitachi IC25N080ATMR04-0 - 3E034 - Dell 80GB Laptop Hard Drive
- Hitachi IC25N040ATMR04-0 - Travelstar 40GB Laptop Hard Drive 9.5mm 2.5 Inch Notebook HDD