Table of Contents
Advertisement
(5) Peel off FB sheet.
(6) Unscrew three (3) fixing screws for Front beam, and then remove Front beam.
[Caution] When you remove Front beam, DO NOT pull RFID reader harness by force.
Front-beam sheet
(7) Unscrew two (2) fixing screws for RFID reader cover, and then remove
RFID reader cover.
(8) Pull out RFID-reader harness from connector.
Fixing screws (2 pieces )
for RFID reader cover
RFID reader cover
(9) Replace RFID reader with a new one. Then attach the removed parts in reverse
order of the procedures above.
[Caution] When you attach Front-beam sheet, be sure to the following
• Replace Front-beam sheet to a new one.
• Confirm that there is NO adhesive remaining on the Front beam.
• Attach the new Front-beam sheet by pushing the Front-beam sheet to
the left side of the convexed frame.
Left side of the convexed frame.
Front beam
When you attach Front beam, be sure that the electrical wires or cables are
NOT to be pinched between any parts.
Front beam
RFID reader harness
(3) points below.
Danger of Electrical shock
3-50
Fixing screws (3 pieces) for Front beam
RFID reader harness
RFID reader cover
RFID reader
Connector
Front-beam sheet
- Quick Links:
- Troubleshooting List
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
Related Manuals for Hitachi IJ UX
Related Products for Hitachi IJ UX
- Hitachi IJ PH
- Hitachi IJ RX2
- Hitachi IJ UX2
- Hitachi IPJ-AW250N
- Hitachi Innovate iPJ-AW250NM
- Hitachi IC25N040ATCS04-0 - Travelstar 40GN 40GB UDMA/100 4200RPM 2MB 2.5" IDE Hard Drive
- Hitachi IC25N080ATMR04-0 - 3E034 - Dell 80GB Laptop Hard Drive
- Hitachi IC25N040ATMR04-0 - Travelstar 40GB Laptop Hard Drive 9.5mm 2.5 Inch Notebook HDD