DCN Next Generation | Installation and User Instructions | Central Devices
10.9.2 Direct camera control without a
PC
This information is the same for the network controller
and the CCU (refer to section 8.9.2), except that:
•
the protocol for RS 232 on the network controller is
permanently set to camera control.
•
the baud rate has to be set with menu item 7I
Camera Cntrl (refer to section 10.10.11).
10.9.3 Video switcher without a PC
This information is the same for the network controller
and the CCU (refer to section 8.9.3), except that:
•
the protocol for RS 232 on the network controller is
permanently set to camera control.
•
the baud rate has to be set with menu item 7I
Camera Cntrl (refer to section 10.10.11).
10.9.4 Direct control with a PC
This information is the same for the network controller
and the CCU (refer to section 8.9.4), except that:
•
the protocol for RS 232 on the network controller is
permanently set to camera control.
•
the baud rate has to be set with menu item 7I
Camera Cntrl (refer to section 10.10.11).
•
the PC is connected to the Ethernet connector, and
the correct IP address has to be set
(refer to section 10.10.11)
10.9.5 Video switcher with a PC
This information is the same for the network controller
and the CCU (refer to section 8.9.5), except that:
•
the protocol for RS 232 on the network controller is
permanently set to camera control.
•
the baud rate has to be set with menu item 7I
Camera Cntrl (refer to section 10.10.11).
•
the PC is connected to the Ethernet connector, and
the correct IP address has to be set
(refer to section 10.10.11)
Bosch Security Systems | 2007-02 | 9922 141 70525
en | 88