Bosch DCN Next Generation Installation & User's Instructions page 53
Digital congress network
Hide thumbs
Also See for DCN Next Generation:
- Installation and operation manual (286 pages) ,
- Operation manual (290 pages) ,
- Installation and user instructions manual (158 pages)
Table of Contents
Advertisement
DCN Next Generation | Installation and User Instructions | Central Devices
8.8. 1 .2
Open
In the Open mode, delegates can enable their
microphones with the microphone button on their
contribution devices. When the maximum number of
delegates speak, the next delegate that enables his or her
microphone is added to a request-to-speak list. The
microphone is not enabled until another delegate
disables his or her microphone.
Note
Microphones of chairman devices can always be
enabled in the Open mode.
8.8. 1 .3
Override
In the Override mode, delegates can activate their
microphones with the microphone button on their
contribution device. When the maximum number of
delegates speak, the next delegate that activates his or
her microphone automatically deactivates the
microphone that was activated for the longest time.
Note
Microphones of chairman units can always be
activated in the Override mode.
8.8. 1 .4
Voice
In the Voice mode, delegates can enable their
microphones with their voices. The maximum number
of delegates that can speak at the same time is the same
as the maximum number of enabled microphones.
Delegates can mute their microphones with the
microphone button on their contribution devices
Note
The LED ring of the microphone (refer to section
17.4) does not come on. But, the LED of the
microphone button is always on.
8.8. 1 .5
PTT
In the PTT (push-to-talk) mode, the delegates can
activate their microphones with the microphone button
on their contribution devices. The microphone is
activated as long as the microphone button is pushed.
When the maximum number of delegates speak, the
other delegates cannot activate their microphones.
Bosch Security Systems | 2007-02 | 9922 141 70525
Note
Microphones of chairman units can always be
activated in the PTT mode.
8.8.2
Audio routing modes
8.8.2. 1
Introduction
You can set the audio routing of audio input 2 and
audio output 2 with the 7G Routing I/O 2 menu item
(see section 8.10.11). The functions of audio input 1 and
audio output 1 of the central control unit cannot be
changed. The signal on audio input 1 is always added to
the floor signal. The signal on audio output 1 is always
suitable to connect the system to an external public
address system.
8.8.2.2
Recorder
In the Recorder mode, audio output 2 of the central
control unit transmits a signal that you can connect to
an external audio recorder (refer to figure 8.12). The
central control unit has no effect on the volume level of
the signal.
In the Recorder mode, the signal on audio input 2 of the
central control unit is added to the floor signal.
en | 53
Advertisement
Table of Contents
