Bosch DCN Next Generation Installation & User's Instructions page 133
Digital congress network
Hide thumbs
Also See for DCN Next Generation:
- Installation and operation manual (286 pages) ,
- Operation manual (290 pages) ,
- Installation and user instructions manual (158 pages)
Table of Contents
Advertisement
DCN Next Generation | Installation and User Instructions | Central Devices
Note
Do not connect an audio input to more than one
bundle channel (in the same or one of the other
receiver bundles). When you connect an audio
input to more than one bundle channel, the
system can operate incorrectly.
6 Enter the values of the other parameters (for
example, the bundle priority) of the receiver bundle
(refer to the on-line help of the CNConfig).
7 Repeat step 4 to 6 for the other bundle channels in
the receiver bundle.
Transmitter bundles
Each transmitter bundle can have 8 bundle channels.
To the bundle channels of a transmitter bundle, you can
connect the audio outputs of the cobranet interface.
Thus, the audio outputs take audio signals from the
optical network and send them to the CobraNet
network.
Do as follows to configure a transmitter bundle of the
cobranet interface:
1 Go to the Advanced Configuration window (refer to
figure 13.10) of CNConfig.
2 In the Bundle Number field of the transmitter
bundle, enter the number of the bundle that the
cobranet interface sends to the CobraNet network
(refer to table 13.13 in the on-line help of the
CNConfig).
table 13. 1 3: Bundle numbers
Bundle number
0
1 to 255
256 to 65279
Note
When the CobraNet network must send the
transmitter bundle to one other device on the
CobraNet network, make sure that the
transmitter bundle is a unicast bundle.
3 Double-click on the first bundle channel (Ch 1) with
the left mouse button. CNConfig shows a
Bosch Security Systems | 2007-02 | 9922 141 70525
Description
Bundle not in use.
Multicast bundle
Unicast bundle
Tx Advanced Configuration window (refer to figure
13.12). With the Tx Advanced Configuration window,
you can change the audio outputs that are connected
to the bundle channels.
figure 13. 1 2: Tx Advanced Configuration window
4 On the right of the Bundle Channel 1 block, click on
the arrow button with the left mouse button. The
CNConfig shows a list of audio outputs that you can
connect to the bundle channel 1.
5 Click on the audio output that must be connected to
the bundle channel. When the cobranet interface
must not use the bundle channel, click on Unused
with the left mouse button.
Note
You can connect an audio output to more than
one bundle channel. When you connect an
audio output to more than one bundle channel,
the system operates correctly.
6 Enter the values of the other parameters of the
transmitter bundle (refer to the on-line help of the
CNConfig).
7 Repeat step 4 to 6 for the other bundle channels in
the transmitter bundle.
en | 133
Advertisement
Table of Contents
