Table of Contents
Advertisement
RPV311
7
DC Channels
RPV311-TM-EN-7
The <R
> button allows user to rename the digital channel.
ENAME
The <R
> button allows user to delete the digital channel.
EMOVE
The signal of the transducer (±10 V or 0-20 mA) is converted in to the desired physical
measurement using a first order transfer function with the parameters of gain (��)
and offset (��) defined by the user:
�� = ���� + ��
where �� is the converted value and �� is the value read by the DC channel in Volts or
Amps.
The RMS value of the DC channels (transducers) is calculated every cycle.
To add a new DC channel select the DC C
The I
text field allows user to enter a single code for the channel being
DENTIFIER
defined (maximum 15 characters). No editing allowed;
The I
scroll box allows user to define the input to which each DC channel is
NPUT
connected. No editing allowed;
The F
REQUENCY REFERENCE
The G
and the O
AIN
FFSET
transducer function;
The U
text field allows user to define the connected transducer unit (maximum 6
NIT
characters, letters only).
Once the DC channel is created, it shows in the configuration interface menu. When
selecting the DC channel, a screen shows the characteristics of the DC channel
selected, as shown in Figure 26. It is possible to edit the frequency reference, gain,
offset and unit.
HANNELS
scroll box allows user to select a reference voltage circuit;
text field allows user to define the transfer connected
Chapter 4 – Configuration
section and fill in the following:
67
- Quick Links:
- Rpv311
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
