Initial Settings Of The I/O Slot Expansion Unit - Hitachi Compute Blade 2000 User Manual

Hide thumbs Also See for Compute Blade 2000:

Table of Contents

Initial settings of the I/O slot expansion unit

The I/O slot expansion unit must be initialized for your environment.

This section describes how to initialize the I/O slot expansion unit.

The following data needs to be initialized:

Password for the administrator account

Setting of device identification information

Setting of network information such as IP addresses

To set items above, use the console functions.

Initial settings via system console

(1) First login

Boot the client software, such as Telnet or Serial terminal software, of the

system console.

Specify 192.168.0.65 to connect the client software, which is not required

for serial connection, and start the connection.

Fixed user account and password are set to Administrator account for the

system console at the time of shipment. Type the following user account and

password to login.

User account

When login is successful, you can type a command to perform.

Compute Blade 2000 I/O slot expansion unit I/O Module

Firmware Revision : A0100-Z-919

Use EX Command to logout.

Use HE Command to get a list of available commands.

5713RF0 00108(0)IOEU>

(2) Password change in Administrator account

See "SO Command" in Chapter 6.

It is recommended that the Administrator account password

Setting at the shipment

administrator

: 5713RF0 00108

Table of Contents