Serial Interface Connection - Hitachi Compute Blade 2000 User Manual

Hide thumbs Also See for Compute Blade 2000:

Table of Contents

Serial interface connection

Select a built-in Fibre-channel switch module to connect using the SCO command

described in Chapter 6. Then connect your setup terminal to the serial port on the

management module installed in the system equipment using the RS-232C cross cable.

When two management modules are installed, connect to the management module

with the Master (MSR) light emitting diode (LED) that lights solid green.

Prepare the RS-232C cross cable for connection.

Requirements for the setup terminal

Communication port

Communication software

Communication

In settings of this system at the time of shipment, the communication speed of the

CONSOLE port is set in 9600 bits/s. Do not use a communication rate other than 9600

RS-232C port

Any of the following communications software

products or its equivalent communication software

- Hyper terminal attached to Windows 2000 or

- Tera Term Pro (Version 2.3)

Communication

ZMODEM protocol

Communication

8 bits, 1 stop bit, no parity

Communication

Setup terminal

Specification

Table of Contents