Command Input Mode Overview - Hitachi Compute Blade 2000 User Manual

Hide thumbs Also See for Compute Blade 2000:

Table of Contents

Command input mode overview

The command line interface for the system supports two command input modes: operation

command mode and configuration command mode.

You can execute operation commands in the operation command mode, and you can execute

configuration commands in the configuration command mode.

The command line interface for the system is classified into two user levels: a general user level

and a system administrator level. Operation command mode supports both the general user

level and system administrator level. Configuration command mode has only the system

administrator level.

The following table lists features of command input modes and details on how to access and

exit command input modes.

General user

administrator

Configuration

administrator

Operation command mode

(for the general user)

If you log in to the system, this mode will be set.

In this mode, you can run some operation commands that are enabled for the general

You cannot register a new user account and delete a user account in the general user

level. The registration and deletion requires the system administrator level.

Operation command mode

(for the system administrator)

If you enter the enable command in the general user mode, this mode will be set.

In this mode, you can use all operation commands.

The enable command is not initially assigned a password. To prevent security

deterioration, it is recommended that you assign a password to the enable command

and restrict system administrator qualifications to a specific user.

Command input modes

Accessed by:

You can use some

operation commands.

You can use all operation

You can use all

configuration commands.

Table of Contents