Sony DFS-700 Service Manual page 9
Dme switcher, digital/analog input board, analog composite input board, digital multi effects board, 3d video mapping effects board
Hide thumbs
Also See for DFS-700:
- Operating instructions manual (212 pages) ,
- Specifications (8 pages)
Table of Contents
Advertisement
Owner's Record
The model and serial numbers are located in the rear.
Record these numbers in the spaces provided below. Refer
to them whenever you call upon your Sony dealer regarding
this product.
Model No.
Serial No.
WARNING
To prevent fire or shock hazard, do not
expose the unit to rain or moisture.
2
For customers in the USA (DFS-700 only)
This equipment has been tested and found to comply with
the limits for a Class A digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own
expense.
You are cautioned that any changes or modifications not
expressly approved in this manual could void your authority
to operate this equipment.
The shielded interface cable recommended in this manual
must be used with this equipment in order to comply with the
limits for a digital device pursuant to Subpart B of Part 15 of
FCC Rules.
Caution
Television prograrms, films, video tapes and other materials
may be copyrighted.
Unauthorized recording of such material may be contrary to
the provisions of the copyright laws.
For the customers in Europe (DFS-700P only)
This product with the CE marking complies with both the
EMC Directive (89/336/EEC) and the Low Voltage Directive
(73/23/EEC) issued by the Commission of the European
Community.
Compliance with these directives implies conformity to the
following European standards:
• EN60950: Product Safety
• EN55103-1: Electromagnetic Interference (Emission)
• EN55103-2: Electromagnetic Susceptibility (Immunity)
This product is intended for use in the following
Electromagnetic Environment(s):
E1 (residential), E2 (commercial and light industrial), E3
(urban outdoors) and E4 (controlled EMC environment, ex.
TV studio).
Table of Contents
Chapter 1
Overview
Features of This System ................................................1-1
Option Boards ................................................................1-3
Chapter 2
Control Panel ................................................................. 2-1
Location and
Processor Unit ..............................................................2-13
Function of Parts
Front Panel ..................................................................... 2-13
and Controls
Rear Panel ...................................................................... 2-13
Chapter 3
Basic Operation
DME Switcher Introduction .......................................... 3-1
Sequence of Operations .................................................... 3-1
Example Operation (1): Wipe........................................... 3-2
Example Operation (2): Picture-in-Picture ...................... 3-5
Demonstration .................................................................. 3-8
Using the Menus ............................................................. 3-10
Selecting Images ......................................................... 3-12
Background Image and Foreground Image .................... 3-12
Selecting Signals Output to the Auxiliary Bus ............... 3-16
Selecting an Effect .......................................................3-17
Types of Effect ............................................................... 3-17
Example Effects ............................................................. 3-18
Selection in Direct Pattern Selection Mode ................... 3-23
Selection in Pattern Number Specification Mode .......... 3-24
Modifying the Boundary — Border, Soft Edge,
Beveled Edge, and Crop .....................................3-26
Changing the Pattern Position and Size —
Location (X)(Y)(Z) ................................................3-29
Modifying the Pattern — User Modifiable Effects .....3-31
(Continued)
3
Table of Contents
- Quick Links:
- Manual Structure
Hide quick links:
Advertisement
Table of Contents
