Important information
If the device is brought in from a cold environment, condensation may form
●
both inside and on the outside of the device.
Wait until the device has acclimatized to room temperature and is absolutely
dry before starting it up. Material damage may be caused to the device if this
requirement is not observed.
Transport the device only in the original packaging or in packaging that
●
protects it from knocks and jolts.
For the Japanese market, transporting the device in its original packaging
does not apply.
Installation and operation
This unit should not be operated in ambient temperatures above 35 °C.
●
If the unit is integrated into an installation that draws power from an industrial
●
power supply network with an IEC309 connector, the power supply's fuse
protection must comply with the requirements for non-industrial power
supply networks for type A connectors.
The unit automatically adjusts itself to a mains voltage in a range of 200 VAC
●
to 240 VAC. (For the Japanese market there are two PSUs available: PSU
for 100V is set to a mains voltage in the range of 100V - 240V). Ensure that
the local mains voltage lies within these limits.
This device must only be connected to properly grounded power outlets or
●
connected to the grounded rack internal power distribution system with
tested and approved power cords.
Ensure that the device is connected to a properly grounded power outlet
●
close to the device.
Ensure that the power sockets on the device and the properly grounded
●
power outlets are easily accessible.
The On/Off button or the main power switch (if present) does not isolate the
●
device from the mains power supply. In case of repair or servicing
disconnect the device completely from the mains power supply, unplug all
power plugs from the properly grounded power outlets.
Always connect the server and the attached peripherals to the same power
●
circuit. Otherwise you run the risk of losing data if, for example, the server is
still running but a peripheral device (e.g. memory subsystem) fails during a
power outage.
Data cables must be adequately shielded.
●
32
Upgrade and Maintenance Manual
CX400 S1