GE MDS SD Series Reference Manual page 90
Secure, long range ip/ethernet & serial
Hide thumbs
Also See for MDS SD Series:
- Technical manual (124 pages) ,
- Quick start manual (4 pages) ,
- Setup manual (4 pages)
Table of Contents
Advertisement
RTU Simulator
82
SD Series Ref. Manual (Packet & Transparent Mode)
6. Select
Start Spectrum Analyzer
key. A results screen is presented showing all detected signals in the
specified range. (See Figure 64). The vertical bars show detected RF
signals. The scale on the left side shows the amplitude level of these
signals in dBm.
Figure 64. Spectrum Analyzer—Results Screen
(Example only--Display will vary with channel conditions)
The unit's built-in RTU simulator generates random data similar to what
would be supplied by an external RTU connected to the radio. It is
useful for system testing within the radio network by providing realistic
data to pass over the radio channel. Proceed as follows to use the RTU
simulator:
1. Select
RTU Simulator
submenu shown in Figure 65 appears.
2. Select
from the menu. A flashing cursor appears in the
RTU Enable
field to the right of the item.
3. Press the spacebar to set this field to
setting.
4. Select
. A flashing cursor appears in the field to the right
RTU Number
of the item. Enter the desired RTU number and press
the setting. The RTU simulator is now operational.
5. To deactivate the RTU Simulator, select
menu and press the spacebar to set the item to
apply the setting.
from the menu and press the
Invisible place holder
from the Radio Test Menu (Figure 62). The
. Press
ON
RTU Simulator
ENTER
to apply the
ENTER
to apply
ENTER
again from the
. Press
to
OFF
ENTER
MDS 05-4846A01, Rev. C
- Quick Links:
- Connecting a Pc & Setting Basic...
Hide quick links:
Advertisement
Table of Contents
