Table of Contents
Advertisement
NOTE
ready to become an ITO managed node when it is later connected to the
network. This may be useful if many workstations are prepared in some
central location, or if one wants to avoid the root connection over the
network that is necessary for a standard agent installation.
Install the Agent on the Managed Node:
Use the following instructions to install the HP-UX agent on an HP-UX
workstation that will become an ITO managed node:
1. Install the agent package files from the ITO management server to
the managed node. You can do this either by copying an SD tape file
to the node, or by using an SD depot. Using an SD tape file allows you
to install the agent without a depot, and without any network
connection. However, if you plan to pre-install many agents, you may
find it more convenient to create and use a depot (see "Creating a
Software Depot on a Remote Node" on page 65).
• Using an SD tape file:
a. Copy the ITO agent package to a temporary directory on the
managed node. On the management server, this agent package
is located in:
for HP-UX 10.x managed nodes:
vendor/hp/s[7|8]00/hp-ux10/< ito_version >/\
RPC_DCE_[TCP|UDP]/opc_pkg.Z
for HP-UX 11.x managed nodes:
vendor/hp/pa-risc/hp-ux11/<ito_version>/\
RPC_DCE_[TCP|UDP]/opc_pkg.Z
If you intend to run ITO Advanced Network Security (ANS) on this node,
you also need to copy the following file from the same directory (HP-UX
10.x/11.x, as appropriate):
b. Uncompress the agent package:
If appropriate, uncompress the ANS package, too:
Chapter 2
Installing ITO Agents on the Managed Nodes
General Installation Tips for Managed Nodes
67
Advertisement
Table of Contents
Troubleshooting
