Panasonic WJ-SX550A Operating Instructions Manual page 30
Matrix switcher and system controller
Hide thumbs
Also See for WJ-SX550A:
- Operating instructions manual (135 pages) ,
- Operating instructions manual (132 pages)
Table of Contents
Advertisement
CPU Board Dip Switch and Jumper Setting
1. Confirm Switches (SW2) on the board are set to the following positions.
These switches are used only for factory test.
Always keep these switches in the positions shown on right in the field.
2. Set the switch (SW4) on the board to match the Sync. input signal, if applicable. Initially, VS
position is selected at the factory.
3. Set the jumper connectors (CN12) on the board to open connection position when a printer is
connected to the board.
4. Set the jumper connector (CN13) on the board to the "C/L" position when the set up menus are
not clearly displayed on the colour monitor.
Initially, the "B/W" position is selected at the factory.
5. Set the jumper connector (CN14) on the board for either VD Output or Status Output from the
VD Output Connector. Initially, the VD position is selected at the factory.
CN12
SW4
CN13
SW2
CN14
Note
-27-
SW2
R
G
CN12
B
SYNC
CN13
B/W
CN13
C/L
CN14
GRAPHIC
CN14
VD
3
Advertisement
Chapters
Table of Contents
