Panasonic WJ-SX550A Operating Instructions Manual page 24
Matrix switcher and system controller
Hide thumbs
Also See for WJ-SX550A:
- Operating instructions manual (135 pages) ,
- Operating instructions manual (132 pages)
Table of Contents
Advertisement
Setting Procedure
1. Operator No.1 has first priority . Cameras 1 - 8 can be selected by MON-1.
2. Operator No.2 has second priority. Cameras 1-5 can be selected by MON-2 (limited access due to operator partitioning).
3. Operator No.3 also has second priority. Cameras 4 - 8 can be selected by MON-3.
1
2
3
4
5
6
7
8
Priority 1
Operator 1
Controller 1
1. In the above system, when Operators 1 and 2 both select the camera No.3 simultaneously, the selection by Operator 1 is
allowed because operator 1 has a higher priority.
2. Operator 2 can not select camera 6 because operator's partitioning limits access to only cameras 1 - 5 by Operator 2.
3. Operator 2 can not control the Monitor 3 because controllers partitioning prevents access to monitor 3 by Operator 2.
13. Synchronizing the Sequence with External Timing
The camera switching interval (Sequence Dwell Time) can be synchronized with the time lapse mode set in the associated Time
Lapse VTR.
Select the On or Off mode to meet monitor requirements.
14. Cable Compensation / VD2
Cable Compensation
This feature is used to compensate for signal loss due to cable length.
The most suitable position for cable-loss compensation can be selected in the Set Up Menu.
Available cable length compensations are shown below.
S: Up to 500m (1,600 ft)
M: 500m (1,600 ft) to 900m (2,900 ft)
L: 900m (2,900 ft) to 1,200m (4,000 ft)
(When using 5C - 2V coaxial cable or equivalent)
VD2 (Camera Gen-lock Signal)
The VD2 (Gen-lock Sync Signal) can be turned On or Off by using the Set Up Menu.
Select VD2 On or Off to meet camera requirements.
15. RS-485 Site Communication
The communication parameters between the Camera Site can be set by using the Set Up Menu, if the optional WV-PB5548E Data
Board is installed in the Matrix Switcher.
The WV-RM70E Camera Controller or a modem is required in the system.
Operator's
Priority
Priority 2
Operator 2
Controller 2
M1
M2
SPOT
SPOT
1
2
3
4
Operator's
Partitioning
5
Priority 2
Controller
Operator 3
Partitioning
Controller 3
SPOT
-21-
4
5
6
7
8
M3
2
Advertisement
Chapters
Table of Contents
