Panasonic WJ-SX550A Operating Instructions Manual page 126
Matrix switcher and system controller
Hide thumbs
Also See for WJ-SX550A:
- Operating instructions manual (135 pages) ,
- Operating instructions manual (132 pages)
Table of Contents
Advertisement
Symptom: The Alarm does not work.
1. Check that the Alarm Mode is selected
2. Check that the Alarm Input (Site or Board) is selected "On" on the Alarm Mode Select Menu in the Set Up Menu.
Symptom: The sequence does not finish even after the programmed time.
1. The sequence, that is activated by the programmed timer, will be continued until the other operation is made after the stop
time.
Symptom: The Group Sequence does not run to synchronized on the monitors that is made the EXT Timing setting from
the connected VTR.
1. The step switching on the Group Sequence depends on the EXT Timing on a lowest number of the monitors that are assigned
to run the Group Sequence.
Symptom: Can't operate the cameras by the Camera Position Numbers.
1. Check that the CAM-P Mode is selected "On" in the CAM-P Menu on the LCD.
2. Check that the Camera Position Numbers are registered correctly by using the Camera Position Test Mode in the CAM-P
Menu on the LCD.
7
" Mode 1 - 3 " or Timer on the Alarm Mode Select Menu in the Set Up Menu.
-122-
Advertisement
Chapters
Table of Contents
