Table of Contents
Advertisement
NOTE:
If you are not familiar with console command or the related parameter, enter
"help" anytime in console to get the help description.
You can change these settings, if desired, after you log on. This management method
is often preferred because you can remain connected and monitor the system during
system reboots. Also, certain error messages are sent to the serial port, regardless of
the interface through which the associated action was initiated. A Macintosh or PC
attachment can use any terminal-emulation program for connecting to the terminal
serial port. A workstation attachment under UNIX can use an emulator such as TIP.
Commands Level
The following table lists the CLI commands and description.
Modes
Access Method
Begin a session with
User EXEC
your switch.
Enter the enable
Privileged
command while in
EXEC
User EXEC mode.
Enter the configure
Global
command while in
Configuration
privileged EXEC
mode.
GE-DS-82 and 82-PoE Ethernet Managed Switch User Manual
Prompt
Exit Method
Enter logout or
switch>
quit.
Enter disable to
switch#
exit.
To exit to
switch
privileged EXEC
(config)#
mode, enter exit
or end
Chapter 5: Console Management
About This Model
The user commands
available at the user
level are a subset of
those available at the
privileged level.
Use this mode to:
• Perform basic tests.
• Display system
information.
The privileged
command is the
advanced mode.
Use this mode to
• Display advanced
function status
• Save configuration
Use this mode to
configure those
parameters that are
going to be applied to
your switch.
143
Advertisement
Table of Contents
