Table of Contents
Advertisement
This page includes the following fields:
OBJECT
Active
Passive
NOTE:
A link having two passive LACP nodes will not perform dynamic LACP trunk
because both ports are waiting for an LACP protocol packet from the opposite device.
Forwarding and Filtering
The frames of Ethernet Packets contain a MAC address (SMAC address), which shows
the MAC address of the equipment sending the frame. The SMAC address is used by
the switch to automatically update the MAC table with these dynamic MAC
addresses. Dynamic entries are removed from the MAC table if no frames with the
corresponding SMAC address have been seen after a configurable age time.
Dynamic MAC Table
Entries in the MAC Table are shown on this page. The Dynamic MAC Table contains up
to 8192 entries, and is sorted first by VLAN ID, then by MAC address. You can view all
of the dynamic MAC addresses learned by the listed port.
GE-DS-82 and 82-PoE Ethernet Managed Switch User Manual
DESCRIPTION
The port automatically sends LACP protocol packets.
The port does not automatically send LACP protocol packets, and
responds only if it receives LACP protocol packets from the opposite
device.
Chapter 4: Web-Based Management
101
Advertisement
Table of Contents
