Table of Contents
Advertisement
How to modify cuts using READY TRIM
Note:
Although it is often easier to rewrite cuts rather than modify
them, the following online functions are available. (Offline
adjustments can be made using the OFFLINE: CUTS GUI).
1
'Ready' Trim enable the cuts to be automated with
the central {READY TRIM} button, or
'Ready' Trim enable the cuts using the 'local'
method described at the beginning of this section.
3
Press {GLOBAL DROP-IN} either before or after
rolling the tape to drop all 'ready' enabled cuts into
automation record, or press switches individually.
To add a new cut:
Adding a new cut in between previous cuts, with no
overlap, is straightforward. Implement as previously
described.
ON
PREVIOUS
TIME
CUT
CUT
4
Press {GLOBAL DROP-OUT} after writing cuts
followed by {PLAY} {ENTER} to hear the result
and note that automated cuts are indicated by
switches lighting amber.
5
Roll back and repeat {GLOBAL DROP-IN} until the
cuts are satisfactory.
6
Press {READY CANCEL} {ENTER} once cuts have
been completed.
Note:
The bi-colour LEDs in the cut switches help with the
operation of these functions. The red light indicates manual
actions and amber those being performed by the computer.
Extra bright red/amber indicates simultaneous manual and
computer control.
NEW CUT
Chapter 7 Session Management
PREVIOUS
CUT
7-73
Advertisement
Table of Contents
